Suitable to cut and trim cores to be prepared for compression tests, where the flatness of both surfaces is a basic condition to obtain correct results.
The equipment is made of stainless steel and aluminum and is supplied complete with diamond blade Ø 180 mm.
For this purpose it must be used the drill mod. C377-10 (enclosed into micro-coring equipment) and the water tank with foot pump mod. C377-01.
Note:
The maximum values foreseen for compression tests on micro-cores are usually lower than 60 kN. Portable compression machine mod. C094N, or a cement compression tester may be conveniently used. Trimming of cores may be even obtained with the grinding machine mod. C299 + device mod. C300-08.